The system equipment of the BRAVO generation is complemented by a wide range of non-contact and tactile electronic probes and integrated tool racks. Continuous wrists and indexable probe heads accept extra-long extensions and automatically orient the measuring sensor to any position, thus optimizing the dimensional inspection cycles of the most complex sheet metal artifacts.

• The open structure with walkable covers along the longitudinal axes ensures maximum ease of access to the measurement area simplifying part loading and unloading operations, programming and automatic dimensional inspection.
• Rigid steel structure for maximum dimensional stability in a wide range of operating conditions
• Axes slide via high-accuracy recirculating ball pads, compressed air is not required
• Rigid ram with 80 x 100 mm section, prewired to accept the optional anticrash protection
• Provision for installation flush to the floor

• Dimensional inspection of thin-walled components, bodyshells, chassis, subassemblies, panels, car doors, glasses, dashboards
• Dimensional inspection of castings, structural aircraft, ship and railway components
• Metrology support to die and mould manufacturing process
• Reverse engineering of complex contoured shapes

Operating environment:

• Metrology labs, QC rooms, Meisterbock rooms
• Metrologic temperature range: 16-24 °C or 16-26 °C

Probing systems:

• Standard: TESASTAR-m
• Optional: CW43L-mw (two axes)
  

*Standard X strokes: 4000, 6000, 7000 & 9000 mm. Strokes and accuracies refer to the single arm configuration. BRAVO HD is available in both single and dual arm configuration.